AZM48A1CH, 1.65 in. (42mm) AZ Series Key Shaft Stepper Motor with Absolute Mechanical Encoder (Connector Type) (AC Input)

The αSTEP AZ Series stepper motor offers closed loop control, substantially reduces heat generation from the motor and by incorporating the newly developed Absolute Mechanical Encoder, absolute-type positioning is available, without battery back up or external sensors to buy.

Round Shaft with Flat
Requires αSTEP AZ Series Driver
Connector Type

*Connection Cables required (sold separately)

Compatible Motors

Unit of Measure

Specifications

Lead Time¹	- {Contact your local sales office for more information.}
Product Line	- Oriental Motor®
Frame Size	- 1.65 in
Motor Length	- 3.86 in.
Driver Voltage Input Power	- AC
Speed-Torque Characteristics	- Speed - Torque Characteristics
Holding Torque	- 109 oz-in
Holding Torque at Motor Standstill	- 54 oz-in
Type	- Absolute Mechanical Encoder
Shaft/Gear Type	- Key Shaft (No Gearhead)
Shaft	- Single
Electromagnetic Brake	- Not Equipped
Connection Type	- Connector
Resolution (Resolution Setting: 1000 P/R)	- 0.36 °/Pulse
Rotor Inertia	- 0.63 oz-in²
RoHS Compliant	- These products do not contain substances that exceed the regulation values in the RoHS Directive.
Safety Standards	- UL CSA CE
CE Marking	- Low Voltage Directives EMC Directives
Insulation Class	- Class B [130ºC (266ºF)] [Recognized as 105 (A) by UL.]
Insulation Resistance	- 100 MΩ or more when 500 VDC megger is applied between the following places: Case - Motor and sensor windings
Dielectric Strength	- Sufficient to withstand the following for 1 minute: Case - Motor and sensor windings 1.5 kVAC 50 Hz or 60 Hz
Ambient Temperature	- 0 ~ 40ºC (32 ~ 104ºF) (non-freezing)
Ambient Humidity	- 85% or less (Non-Condensing)
Degree of Protection	- IP66 when connecting the connection cable (excluding the mounting surface and connector on the driver side of the connection cable)
Stop Position Accuracy	- ±4 arc minutes (±0.067º)
Permissible Overhung Load	- 0 in. from Shaft End = 6.7 lb0.2 in. from Shaft End = 7.8 lb0.39 in. from Shaft End = 9.9 lb0.59 in. from Shaft End = 13 lb0.79 in. from Shaft End = 19.1 lb
Permissible Axial Load	- 3.3 lb