Product Line |
- VEXTA® |
Motor Type |
- IP65 Rated Closed Loop |
Frame Size |
- 3.35 in85 mm |
Motor Length |
- 4.33 in.110 mm |
Speed-Torque Characteristics |
-
 Speed - Torque Characteristics |
Holding Torque |
- 280 oz-in2 N·m |
Type |
- IP65 Rated |
Shaft/Gear Type |
- Round Shaft (No Gearhead) |
Feedback Device (Motor) |
- Resolver |
Electromagnetic Brake |
- Not Equipped |
Shaft |
- Single |
Power Supply |
- Single-Phase 100-115 VAC |
Current |
- 6.0 A |
Resolution |
- 0.36 ° |
Resolution Setting: 1000 P/R |
- 0.36 °/Pulse |
Rotor Inertia |
- 7.7 oz-in²1400x10-7 kg·m² |
RoHS Compliant |
- Yes |
Safety Standards |
- UL CSA EN CE |
CE Marking |
- Low Voltage Directives EMC Directives |
Insulation Resistance |
- [Motor] 100 MΩ minimum when measured by a 500 VDC megger between the frame-windings and frame-electromagnetic brake windings. [Driver] 100 MΩ when measured by a 500 VDC megger between the frame-power supply input terminal and I/O-Power supply input terminal. |
Insulation Class |
- [Motor] Class B [266ºF (130ºC)] [UL/CSA: Recognized as Class A 221ºF (105ºC)] |
Dielectric Strength (Motor) |
- Sufficient to withstand the following for one minute: Frame-Windings 1.0 kV 50 Hz, Frame-Electromagnetic brake windings 1.0kV 50 Hz |
Dielectric Strength (Driver) |
- Sufficient to withstand for 1 min. - Frame-Power supply input terminal 1.5 kV 50 or 60 Hz, I/O-Power supply input terminal 1.8 kV 50 or 60 Hz |
Ambient Temperature Range |
- [Driver] 32ºF ~ 104ºF (0ºC ~ 40ºC) [Motor] 32ºF ~ 122ºF (0ºC ~ 50ºC), nonfreezing |
Ambient Humidity |
- 85% or less (noncondensing) |
Operating Atmosphere |
- No corrosive gases. |
Components |
- ASD30A-AP (Driver) ASM98AAT (Motor) |
Static Angle Error |
- ±5 minutes |
Shaft Runout |
- 0.002 in. (0.05 mm) T.I.R. |
Concentricity |
- 0.003 in. (0.075 mm) T.I.R. |
Perpendicularity |
- 0.003 in. (0.075 mm) T.I.R. |
Permissible Overhung Load |
- 0 in. from Shaft End = 58 lb0.2 in. from Shaft End = 65 lb0.39 in. from Shaft End = 76 lb0.59 in. from Shaft End = 87 lb0.79 in. from Shaft End = 108 lb0 mm from Shaft End = 260 N5 mm from Shaft End = 290 N10 mm from Shaft End = 340 N15 mm from Shaft End = 390 N20 mm from Shaft End = 480 N |
Permissible Thrust Load |
- The permissible thrust load shall be no greater than the motor mass. |
