Return Policy |
N/A This product cannot be cancelled or returned once the order has been processed. |
Frame Size |
N/A 7.87 in200 mm |
Output Table Supporting Bearing |
N/A Cross-Roller Bearing |
Permissible Torque |
N/A 440 lb-in50 N·m |
Inertia |
N/A 916400x10-7 kg·m²5000 oz-in² |
Permissible Speed (r/min) |
N/A 110 |
Gear Ratio (X:1) |
N/A 18 :1 |
Max. Holding Torque |
N/A 310 lb-in36 N·m |
Resolution (Resolution Setting: 1000 P/R) |
N/A 18000 P/R (0.02º) |
Power Supply |
N/A Single-Phase 200-240 VAC |
Frequency |
N/A 50/60 Hz |
Input Current |
N/A 3.70 A |
Shaft |
N/A Double |
Electromagnetic Brake |
N/A Not Equipped |
Control Power Supply |
N/A 24 VDC ±5% 0.5 A |
Repetitive Positioning Accuracy (arc sec) |
N/A ±15 arc sec (±0.004º) |
Lost Motion |
N/A 2 arc minute (0.033°) |
Angular Transmission Accuracy |
N/A 2 arc minute (0.033º) |
Permissible Thrust Load |
N/A 4000 N900 lb |
Permissible Moment Load |
N/A 100 N·m880 lb-in |
Runout of Output Table Surface |
N/A 0.015 mm0.0006 in. |
Runout of Output Table Inner (Outer) Diameter |
N/A 0.030 mm0.0012 in. |
Parallelism of Output Table |
N/A 0.05 mm0.002 in. |
Degree of Protection |
N/A [Actuator] IP20 [Driver] IP10 |
Insulation Class |
N/A 130 (B) |
Insulation Resistance (Actuator) |
N/A 100 MΩ minimum when measured by a 500 VDC megger between the Case - Motor and Sensor Windings |
Insulation Resistance (Driver) |
N/A 100 M Ω minimum when measured by a 500 VDC megger between the PE Terminal - Power Input Terminal |
Dielectric Strength (Actuator) |
N/A No abnormality is found with the following application for 1 minute: Case - Motor and Sensor Windings 1.5 kV, 50 Hz or 60 Hz |
Dielectric Strength (Driver) |
N/A
No abnormality is found with the following application for 1 minute: PE Terminal - Power Supply Terminal 1.8 kV, 50 Hz or 60 Hz Signal I/O Terminal - Power Supply Terminal 1.9 kV, 50 Hz or 60 Hz |
Ambient Temperature (Actuator) |
N/A
0 ~ +50ºC (+32 ~ 122ºF)(non-freezing) 0 ~ +40ºC (+32 ~ 104ºF)(non-freezing) when home-sensor set (accessory is attached) |
Ambient Temperature (Driver) |
N/A 0 ~ +55ºC (+32 ~ 131ºF)(non-freezing) |
Ambient Humidity |
N/A 85% max. (Non-condensing) |
Operating Atmosphere |
N/A Use in an area without corrosive gases and dust. The product should not be exposed to water, oil or other liquids. |
Safety Standards |
N/A CE |
RoHS Compliant |
N/A Yes |
California Proposition 65 |
N/A
⚠ CA WARNING Cancer risk from exposure to Nickel. See www.P65Warnings.ca.gov Risk of reproductive harm from exposure to Di-n-hexyl phthalate (DnHP). See www.P65Warnings.ca.gov Risk of cancer and reproductive harm from exposure to Di(2-ethylhexyl phthalate (DEHP). See www.P65Warnings.ca.gov See "?" or copy/paste www.P65Warnings.ca.gov in your browser. |
Components |
N/A ARD-CD (Driver) DGM200R-ARBC (Actuator) |
Number of Positioning Data Sets |
N/A 64 Points |
Positioning Operation |
N/A Independent, Linked, Linked 2, Sequential, Direct |
Protocol |
N/A Modbus Protocol (Modbus RTU mode) |
Electrical Characteristics |
N/A
EIA-485 based Use twisted-pair wire (TIA/EIA-568B CAT5e or greater recommended), and set a max. total length of 50 m (164 ft.) |
Transmission/Reception Mode |
N/A Half-duplex communication |
Baud Rate |
N/A 9600 bps/19200 bps/57600 bps/115200 bps |
Physical Layer |
N/A Start-stop synchronization mode (Data: 8-bits, stop bit: 1-bit/2-bit, parity: none/even numbers/odd numbers) |
Connection Type |
N/A Up to 31 units can be connected to one programmable controller (master equipment). |
|
|
|
|
|
|
